- Information Commands
- bdinfo - print Board Info structure
- coninfo - print console devices and informations
- flinfo - print FLASH memory information
- iminfo - print header information for application image
- imls - list all images found in flash
- help - print online help
- Memory Commands
- base - print or set address offset
- crc32 - checksum calculation
- cmp - memory compare
- cp - memory copy
- md - memory display
- mm - memory modify (auto-incrementing)
- mtest - simple RAM test
- mw - memory write (fill)
- nm - memory modify (constant address)
- loop - infinite loop on address range
- Flash Memory Commands
- cp - memory copy (program flash)
- flinfo - print FLASH memory information
- erase - erase FLASH memory
- protect - enable or disable FLASH write protection
- Execution Control Commands
- autoscr - run script from memory
- bootm - boot application image from memory
- bootelf - Boot from an ELF image in memory
- bootvx - Boot vxWorks from an ELF image
- go - start application at address 'addr'
- Network Commands
- bootp - boot image via network using BOOTP/TFTP protocol
- cdp - Perform Cisco Discovery Protocol network configuration
- dhcp - invoke DHCP client to obtain IP/boot params
- loadb - load binary file over serial line (kermit mode)
- loads - load S-Record file over serial line
- nfs - boot image via network using NFS protocol
- ping - send ICMP ECHO_REQUEST to network host
- rarpboot- boot image via network using RARP/TFTP protocol
- tftpboot- boot image via network using TFTP protocol
- Environment Variables Commands
- printenv- print environment variables
- saveenv - save environment variables to persistent storage
- askenv - get environment variables from stdin
- setenv - set environment variables
- run - run commands in an environment variable
- bootd - boot default, i.e., run 'bootcmd'
- Filesystem Support (FAT, cramfs, JFFS2, Reiser)
- chpart - change active partition
- fsinfo - print information about filesystems
- fsload - load binary file from a filesystem image
- ls - list files in a directory (default /)
- fatinfo - print information about filesystem
- fatls - list files in a directory (default /)
- fatload - load binary file from a dos filesystem
- nand - NAND flash sub-system
- reiserls- list files in a directory (default /)
- reiserload- load binary file from a Reiser filesystem
- Special Commands
- i2c - I2C sub-system
- doc - Disk-On-Chip sub-system
- dtt - Digital Thermometer and Themostat
- eeprom - EEPROM sub-syste
- fpga - FPGA sub-system
- ide - IDE sub-system
- kgdb - enter gdb remote debug mode
- diskboot- boot from IDE device
- icache - enable or disable instruction cache
- dcache - enable or disable data cache
- diag - perform board diagnostics (POST code)
- log - manipulate logbuffer
- pci - list and access PCI Configuraton Space
- regdump - register dump commands
- usb - USB sub-system
- sspi - SPI utility commands
- Miscellaneous Commands
- bmp - manipulate BMP image data
- date - get/set/reset date & time
- echo - echo args to console
- exit - exit script
- kbd - read keyboard status
- in - read data from an IO port
- out - write datum to IO port
- reset - Perform RESET of the CPU
- sleep - delay execution for some time
- test - minimal test like /bin/sh
- version - print monitor version
- wd - check and set watchdog
- ? - alias for 'help'
