A fast and simple way to write new data to flash memory is via the use of
a debugger or flash programmer with a
BDM or
JTAG
interface. In cases where there is no running firmware at all
(for instance on new hardware), this is usually the only way to
install any software at all.
We use (and highly recommend) the
BDI2000/BDI3000
by
Abatron .
Other
BDM /
JTAG debuggers may work too, but how to use them is
beyond the scope of this document. Please see the documentation for
the tool you want to use.
Before you can use the BDI2000 you have to configure it. A
configuration file that can be used with canyonlands boards is included in
section
13.3. BDI2000 Configuration file
To install a new U-Boot image on your canyonlands board using a BDI2000,
proceed as follows:
Note: Included topic
DULGData_canyonlands.InstallUBootUsingBDI2000? does not exist yet