DENX . DULG . UBootInstallBefore

5.4.1. Before You Begin Installation Requirements

The following section assumes that flash memory is used as the storage device for the firmware on your board. If this is not the case, the following instructions will not work - you will probably have to replace the storage device (probably ROM or EPROM) on such systems to install or update U-Boot. Board Identification Data

All canyonlands boards use a serial number for identification purposes. Also, all boards have at least one ethernet (MAC) address assigned. You may lose your warranty on the board if this data gets lost. Before installing U-Boot or otherwise changing the software configuration of a board (like erasing some flash memory) you should make sure that you have all necessary information about such data.

----- Revision r1.4 - 24 Nov 2011 - 11:02 - HeikoSchocher
Copyright © 2002-2020 by DENX Software Engineering