Skip to main content.

5.4.1. Before You Begin

5.4.1.1. Installation Requirements

The following section assumes that flash memory is used as the storage device for the firmware on your board. If this is not the case, the following instructions will not work - you will probably have to replace the storage device (probably ROM or EPROM) on such systems to install or update U-Boot.

5.4.1.2. Board Identification Data

Note: Included topic DULGData.canyonlandsBoardId? does not exist yet

5.4. Installation 1. Abstract 5.4.2. Installation Using a BDM/JTAG Debugger
Prev Home Next