Skip to main content.

9.8. The Persistent RAM File system (PRAMFS)

The pramfs file system supports persistent memory devices such as SRAM. Instead of having a block emulation layer over such a memory area and using a normal file system on top of that, pramfs seeks to induce minimal overhead in this situation. Most important in this respect is that the normal block layer caching of the Linux kernel is circumvented in pramfs.

9.8.1. Mount Parameters

The most important parameters for normal usage are

9.8.2. Example

We will show a sample usage of pramfs in this section using normal DRAM on a board with at least 256MB of memory. For pramfs we reserve the upper 32MB by appending mem=224M to the kernel command line.

First off we generate some testdata on a persistent file system (/tmp) to demonstrate that pramfs survives a reboot (of course with power always applied to keep the DRAM refreshed):

bash-3.00# dd if=/dev/urandom bs=1M count=8 of=/tmp/testdata
8+0 records in
8+0 records out

Next we mount the 32MB that we reserved and initialize it to be 32MB in size and copy the testfile. A final compare shows that the copy was indeed successful so we can reboot:

bash-3.00# mount -t pramfs -o physaddr=0xe000000,init=0x2000000 none /mnt
bash-3.00# cp /tmp/testdata /mnt
bash-3.00# cmp /tmp/testdata /mnt/testdata
bash-3.00# reboot

Having rebooted (using mem=224M on the kernel command line again of course) we mount the file system but this time without the init parameter because it is preinitialized. We then check the contents again:

bash-3.00# mount -t pramfs -o physaddr=0xe000000 none /mnt
bash-3.00# ls /mnt
bash-3.00# cmp /tmp/testdata /mnt/testdata
9.7. Overlay File Systems 1. Abstract 10. Debugging
Prev Home Next